CCIE Lab分解实验练习(Plannet_Practice_Labs)_.Vol_2

ccie,java,安全,教程,文集,资料,工具书

本文由cuiguohao66贡献
pdf文档可能在WAP端浏览体验不佳。建议您优先选择TXT，或下载源文件到本机查看。
IT认证部落 CCIE-LAB
CCIE Lab Practice Exam II
Introduction
Advanced Practice Lab for the CCIE R&S Lab Exam
Introduction
This is an additional 4 hours of advanced material. This material will build on top of the previous CCIE Practice lab (Practice CCIE Lab Exam I). There is no need to erase any previous configuration, and the final configurations used for part 1 will be used as the starting configurations for this lab.
Network Diagrams
Practice Lab for the CCIE R&S Lab Exam Part II
The applicable network diagrams are shown below: Diagram 1: IP Addressing/Network Topology
Study Guide From
IT认证部落 CCIE-LAB
Diagram 2: Routing Protocol Topology
Study Guide From
IT认证部落 CCIE-LAB
Lab Configuration Tasks Configuration Tasks
Study Guide From
IT认证部落 CCIE-LAB
Note: CCIE Lab Practice Exam I must be completed before this lab, as the final lab configurations is used as the starting point for this lab.
1.0 Switching STEP 1 (2 points)
1. Make sure that you can adjust the configuration of the range of ports, 19 - 20, using the name "Ether".
STEP 2 (2 points)
1. Ensure that port 0/15 on CAT1 will not forward normal traffic until the device connected to it has authenticated with the RADIUS server at 140.4.55.5 using the default authentication port and the key "cisco".
STEP 3 (2 points)
1. Using an extended named access list on CAT2, block all traffic from Ethernet Type 6000 on port 0/5.
2.0 OSPF STEP 1 (2 points)
1. Configure the link between CK6 and CK8 with Clear Text Authentication using the password "ccie".
STEP 2 (2 points)
1. Setup area 100 to use MD5 authentication with the password "cisco".
3.0 Redistribution STEP 1 (2 points)
1. Ensure that the RIP routes are seen as a single route past CAT1. No NULL0 routes should be seen in any routing table.
4.0 BGP STEP 1 (2 points)
Study Guide From
IT认证部落 CCIE-LAB
1. Shut down CK6's Frame Relay interface and ensure that CAT2 can still ping the 211.1.1.1 address and that CAT1 can still ping the 199.36.36.36 address.
STEP 2 (1 point)
1. AS 100 should receive the 199.36.36.0/24 network with a metric of 1000 from CAT1 -- do not change anything on the Backbone router.
5.0 DLSW + STEP 1 (2 points)
1. Ensure that all of the routers that CK6 may peer with know that it has no available NetBIOS. Do this without the use of an access list.
6.0 CAR STEP 1 (4 points)
1. Apply
queuing inbound on CK13's ATM 2/0 interface such that: a. Any DNS traffic that conforms to 1 Mbps with a normal burst of 1.5 Mbps and a maximum